How do I reset my sensor station?

How do I reset my sensor station?

Open the electronics box and press the button outlined in red below. 


Sensor Station Reset Button

You're all set! If you're still having trouble, check out our sensor station cheat sheet guide

    • Related Articles

    • What should I do if my sensor station is 'offline'?

      Step 1: Reset the sensor station. Reset the sensor station. Check the lights on the sensor station circuit board (see this article for more information). If the sensor station is having trouble communicating with the base station, reset the base ...
    • Why isn't my sensor station showing up on the map on the Dashboard?

      If your hardware is not showing up on your map, you need to press the reset button identified by the red box below. The GPS coordinates will update the next time the sensor station sends data to the base station.
    • What do the lights on the sensor station circuit board mean?

      The lights on the circuit board help you understand how the sensor station is working. Inside the top of your sensor station electronics box, you should see the following 'cheat sheet' Sensor Station Cheat Sheet 'Good' If the sensor station can ...
    • What is the maximum range of the sensor station to the base station?

      Our sensor stations can transmit to a base station that is 1 to 2 miles away.  Line-of-sight (rather than range) to the central base station is the most important factor to consider when choosing where to install your sensor stations.
    • How does the sensor station measure soil moisture?

      We use Irrometer's Watermark sensors & Sentek's Drill & Drop sensors to measure moisture. Each Watermark sensor station contains between up to 5 Irrometer Watermark soil moisture sensors, which have been used & trusted by growers for nearly 40 years. ...